How To Install Pull Down Kitchen Faucet

How to Replace a Kitchen Faucet

CCO/kaboompics/Pixabay

Kitchen faucets are probably one of the most used fixtures in homes. Many times a day the water is turned on and off, leading to quite a bit of wear and tear on this hardworking fixture. If your faucet has seen amend days, or is out of fashion, you can replace it with a shiny new version using but a few tools. Exchanging your onetime kitchen faucet with a new one can transform the look and functionality of your kitchen in just a couple of hours.

Tools you lot'll Need

Have all the necessary tools for this DIY project lined up earlier you beginning to save yourself fourth dimension and frustration.

• New Faucet
• Channel locking pliers
• Basin wrench
• Plumber's Putty
• Adjustable Wrench
• Flexible supply lines
• Tape Measure

Turn off the hot and common cold h2o shut-off valves. they're usually located in the cabinet that's under the sink. Then open up up the faucet to relieve pressure level.

Removing the Erstwhile Faucet

• Step 1: Using an adaptable wrench and a pair of channel locking pliers, disconnect both the h2o lines from the faucet. If the supply lines are former, or the gaskets are worn out, you may want to replace them with flexible supply lines.
• Step Two: Using a socket wrench or basin wrench remove the nut that is holding the faucet tailpiece assembly in place. Sometimes it'south difficult to loosen sometime faucet nuts, in that case try soaking the threads with penetrating oil and try again.
• Pace Iii: If your sink has a line that connects the hose to the faucet you can disconnect this.
• Step Four: Pull the old faucet out and clean the sink'southward surface making sure to remove any rust or caked on debris.

Installing the New Faucet

• Step Ane: Using the measuring record, measure the distance, from heart to center, of the outside holes of your sink. This is to brand sure the new faucet volition fit. Since all faucets are slightly different, read whatever installation instructions that come with your new faucet. Follow all manufacturer'southward pre-assembly instructions and place the optional flange over the faucet opening.
• Step Two: Seal the new faucet. If yous're using a gasket, place the gasket on the lip of the plate and thread the hoses through. If using plumber's putty, apply information technology effectually the base of the faucet and set the faucet in place.
• Footstep 3: Under the sink you lot can now thread on the flange and nut using a socket or basin wrench.
• Step Four: If you're using pull-out faucets, a weight needs to be added that will retract the pull-out spray.
• Step Five: Now it's fourth dimension to attach the supply lines to the faucet and and then to the close-off valves. Cold water connects on the correct and hot water on the left.
• Step Six: Plow on the water and check for leaking. If y'all find any leaks you'll demand to tighten the connections on the water supply line.

More than FROM QUESTIONSANSWERED.NET

Source: https://www.questionsanswered.net/article/how-to-replace-a-kitchen-faucet?utm_content=params%3Ao%3D740012%26ad%3DdirN%26qo%3DserpIndex

Posted by: mitchellthemot.blogspot.com

Share this post